Turning the timber correctly will leave a nice smooth surface. However, to get our timber ready for the final finish we must still carry out some sanding of the surface
_________________________________________________________
The following rules should be followed while sanding on the lathe:
- The lathe speed should be lowered to about 300-500 rpm to avoid burning
- The tool rest must be removed to avoid
coming in contact with it
- Use both hands to support the abrasive paper
- Always sand under the piece so any dust or abrasize is thrown clear from the user
- Always wear a dust mask while sanding on the lathe
- Use progressively smoother Abrasive Paper grits: 120->180->240
__________________________________________________________
Below is a simple video on sanding on the lathe:
__________________________________________________________
A large range of finishes are available to be used with turned wood:
